Digital Indicator

		Digital Indicator　/　LOADCELL INTERFACE ONLY FOR PLC

		●Type directly connected with PLC：It is possible to connect it directly to PLC as an I/O unit.

F130

LOADCELL INTERFACE FOR OMRON SYSMAC CJ1

Loadcell interface allowing direct connection to the bus of OMRON SYSMAC CJ1
Sensor output is quickly loaded as a digital value, and directly output to the CPU.　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　
High speed A/D conversion 3000times/sec
Necessary points are reliably captured by high-speed sampling following dynamic changes.
Downsizing of production line
Waste in production line construction is thoroughly eliminated to realize substantial cost reductions and high added value.
・Completely seamless communication between CJ1 and F130.
・Shortening of measurement system development time, and easy maintenance control, modification,
　and maintenance.
・Remarkable simplification of equipment wiring.
・Cost advantages.



		●Type for fieldbus：It is possible to connect it with each fieldbus such as DeviceNet, CC-Link.

F381

Dynamic Force Processor

Waveform comparison function（Sequential comparison of HI/LO limit waveform and actual measurement waveform）
Multi hold function （HI/LO limit comparison is carried out by changing the type of hold function in each divided measurement segments）
Standard equipped with displacement input（A 2-dimentional waveform comparison is possible by using both force and displacement inputs）
Measurement data and setting values can be saved into a SD card
Parameter setting can be effortlessly performed by a direct touch on the touch panel.
Plus common and minus common are shared, and Sink/Source type is selectable
4000 times/sec high-speed digital processing

F395

Dynamic Force Processor

After digitizing the signal of a sensor and carrying out filtering and operation processing by high-speed(up to 4000 times/sec) A/D and a D/A converter, it can be used as a signal conditioner outputted as an analog signal by which the scaling was carried out.
Multi-hold is the mode which detects the required item in the displayed wave and judges upper/lower comparison. It can memorize 32ch data which is hold type, upper/lower value, etc, and it can select with an external signal.
LCD with touch-panel display excellent in visibility and operativity, such as a measurement value display and a wave display, is adopted.

F372

Graphic Display Digital Indicator

Replacement Model of F370/F371 with Expansion functions.
Expansion functions of the F372:
--Double Hold.
--Before Value Comparison.
--Relative Value Comparison.(In Double Hold only)
--Digital Filter Character selection.
--Trigger Edge selection.
--Pre Trigger display.
To all persons who use the F370/F371-Smooth replacement can be made because the F372 is compatible with the F370/F371 in terms of setting methods and functions except for the use of the expansion functions.

F377

Graphic Display Digital Indicator for Voltage・Current output Sensor

Can be connected directly to Voltage ±10V, Current ±20mA.
The changes in physical quantity are displayed in the waveform.
Various Hold functions that enable to hold accurate point and the function of OK/NG judgment.
Two points Hold (previously measured value comparison, relative value comparison etc.) that can perform two types of Hold simultaneously are installed.
Compact size of DIN96 □
High-speed digital processing capability of 2000 times/sec.

F370

Graphic Display Digital Indicator

Color liquid crystal display and touch operation provide clear indication and easy handling.
Equivalent Input Calibration makes easy calibration by inputting the Rated Value of a sensor by the touch panel.
One touch Zero Function.
Compact Square DIN96 size.
High speed HIGH/ LOW limit comparison function.

*F370/F371 are being shifted to brand new model, F372 currently.
Please ask our sales department for production termination schedule of F370/F371.

F371

Graphic Display Digital Indicator